3D-Print - A box
Once again, I didn't take many screenshots. But my first step was to make a cube then stretch it for it to have a more rectangular shape. I later created a smaller version of that shape and placed it in the middle and cut it to make room inside my box.
I then made a lid for it and did the same step for the inside, to create more room. I felt as if my box was looking a bit boring so I placed a DXF file of a star and placed it on top of the lid to cut through then placed another star in the middle of my box to create a dent.
Here's the inside of the box. As you've seen in the previous picture, I also added dividers. I added cubes then flattened them as much as I could then joined them in the inside of my box.
Here's where my star dent is. I'll most likely use it or rings. That is all.
